| Del nr | Tillverkare | Ansökan |
|---|
| MAX144BEPA | MaximIC | +2.7 V, low-power, 2-channel, 108 ksps, serial 12-bit ADC. INL(LSB) +-1 |
| MAX4074BCESA | MaximIC | Micropower, Rail-to-Rail, fixed-gain, single, GainAmp op amp. Inverting gain 15V/V, noniverting gain 16.5V/V, -3dB BW 54kHZ. |
| MAX186AMJP | MaximIC | Low-power, 8-channel, serial 12-bit ADC. |
| MAX6241BMJA | MaximIC | Low-noise, precision, +4.096V output voltage reference. Max TEMPCO (ppm/C) 8.0. |
| MAX3110ECWI | MaximIC | SPI/MICROWIRE-compatible UART and +-15kV ECD-protected RS-232 transceiver with internal capacitor. Single-supply operation +5V. Vcc (V) 5 |
| MAX6320PUK35DW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 3.500V, reset timeout(min) 1.12sec, watchdog timeout(typ) 6.3ms |
| MAX6347XR36-T | MaximIC | Microprocessor supervisory circuit (reset output active-high, push-pull). Reset threshold (typ) 3.600V. Order increment 10k |
| MAX6316LUK41DZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 4.100V, min reset timeout 1120ms, typ watchdog timeout 25.6sec |
| MAX775C/D | MaximIC | -12V or adjustable, high-efficiency, low IQ inverting DC-DC controller |
| REF02EP | MaximIC | +5V precisioon voltage reference. Max TEMPCO 8.5ppm/degC. Initial error +-15mV |
| MAX1232CSA | MaximIC | Microprocessor monitor |
| MAX8860EUA33 | MaximIC | Low-dropout, 300mA linear regulator. Vout = +3.30V |
| MAX113CAG | MaximIC | 3 V, 400 ksps, 4-channel, 8-bit ADC |
| MAX6316LUK27CW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,push/pull).Factory-trimmed reset threshold (typ) 2.700V, min reset timeout 140ms, typ watchdog timeout 6.3ms |
| MAX6318MHUK41AW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.100V, reset timeout(min) 1ms, watchdog timeout(typ) 6.3ms |
| MAX6310UK46D2-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,negative overvoltage reset input).Factory-trimmed reset thresholds 4.514(min),4.746(max). Nominal timeout period 20ms. |
| MAX190AENG | MaximIC | Low-power, 12-bit sampling ADC with internal reference and power-down. Error(LSB) +-1/2. |
| MAX6317HUK25BX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 2.500V, min reset timeout 20ms, typ watchdog timeout 102ms |
| MAX6318MHUK43AW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.300V, reset timeout(min) 1ms, watchdog timeout(typ) 6.3ms |
| MAX709SEUA | MaximIC | Power-supply monitor with reset. Reset threshold voltage 2.93V |
| MAX798ESE | MaximIC | High-accuracy, step-down controller with synchronous rectifier for CPU power. 1.6V to 6V adjustable precision output. |
| MAX1487CPA | MaximIC | Low-power, slew-rate-limited RS-485/RS-422 transceiver. Half-duplex. Data rate 2.5Mbps. Slew-rate limited - no. Low-power shutdown - no. Receiver/driver enable - yes. Quiescent current - 230 microA. Number of transmitter on bus - 128. |
| MX7528LEPP | MaximIC | CMOS dual 8 bit buffered multiplying DAC. +5V to 15V single supply operation. Error +-1/2 LSB. |
| MAX126CCAX | MaximIC | 2x4-channel, simultaneous-sampling 14-bit DAS. INL (LSB) +4,-4 |
| MAX465EWG | MaximIC | Two-channel, triple RGB switch and buffer. Voltage gain 2V/V. |
| MAX3241EUI | MaximIC | 3.0V to 5.5V, low-power, up to 1Mbps, true RS-232 transceiver using four 0.1microF external capacitor. Low supply current 300microA. Guaranteed data rate 120kbps. |
| MAX4507EWN | MaximIC | Fault-protected, high-voltage, signal-line protector |
| MAX6321HPUK50DW-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 5.000V, reset timeout(min) 1.12sec, watchdog timeout(typ) 6.3ms |
| MAX8874SEUK-T | MaximIC | Low-dropout, 120mA linear regulator with auto-discharge function. Preset output voltage 2.84V. |
| MAX6004EUR-T | MaximIC | Low-cost, low-power, low-dropout, voltage reference. Output voltage 4.096V, input voltage (Vout+200mV) to 12.6V. |
